All New Material Polyester Fiber & Plastic Stiffener & Polyurethane Foam.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or experienced radio/TV technician for help.Attention: Remove all the plastic tags as these are not part of the item. Attention: batteries are included for demonstration, and not intended as part of the purchase price of the product. It is recommended that they should be replaced with 2 (AA) alkaline batteries at time of purchase. When the product is not working or the sound is weak and distorted, the batteries need be changed. Keep packaging for reference since it contains important information. Don’t forget the batteries! This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
Batteries included. For age 3 years and up.
Instructions: Placing or replacing batteries is recommended only under adult supervision. To insert batteries, use screwdriver to unscrew and lift battery case cover at the bottom/back of product or open pouch and reach inside for battery box, loosen screw and lift cover. Carefully insert 2 (AA) batteries. Replace the battery case cover and tighten screw, and your electronic product is ready to operate. Battery Usage: Do not use rechargeable batteries. Use only the batteries recommended. Do not mix different battery types. Do not mix old and new batteries. Do not mix alkaline, standard (Carbon-zinc), or rechargeable (Nickel-cadmium) batteries. Remove batteries when product is not in use. Remove exhausted batteries from product and dispose of in accordance with the manufacturer's recommendation. Do not attempt to recharge non-rechargeable batteries. Batteries are to be inserted with correct polarity. The supply terminals are not to be short-circuited. Do not dispose of batteries in fire, batteries may explode or leak. Replace all batteries of a set at the same time. Clean the battery contacts and also those of the device prior to battery installation. Remove used batteries promptly.
Dan Dee International