Command Damage-Free Hanging Bath Razor Holder

Command Damage-Free Hanging Bath Razor Holder

1 ea pkg


Caution: do not use with wallpaper. May not adhere well to vinyl surfaces. Do not use for antiques, heirlooms, or other valuable or irreplaceable items. Do not hang items over beds. Note: apply to surfaces above 15 degrees F. Adhesive could lose adhesion above 125 degrees F. Not intended for picture hanging. Instead use Command™ picture hanging strips, sawtooth or wire-backed hangers.


Command™ Brand Damage-Free Hanging Bath Razor Holder. New! Holds 1,3 kg 3 lb. Holds strongly in wet conditions. Water resistant adhesive strips. Tested & proven to hold better than suction cups. 1 razor holder. 1 medium adhesive strip. 3M. Razor holder can be reused with blue Command™ medium water resistant strips. The following statements only apply to products distributed in the USA. Limited warranty: this 3M product will be free from defects in material and manufacture. If this product is defective, your exclusive remedy shall be, at 3M's option, replacement of the product or refund of the purchase price. Limitation of liability: 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential. Razor holder made in Mexico. Strips made in U.S.A. with U.S. and globally sourced materials. 3M and Command are trademarks of 3M. 1-800-934-7355. For questions, ideas and special offers go to ©2013, 3M. All rights reserved.

To apply: 1. Select location: if possible, choose a location where strips are not over grout lines. Important: allow space above holder for removal. 2. Clean & dry surface: clean surface with isopropyl rubbing alcohol, let dry. Do not use household cleaners to prep the surface. Separate strips. 3. Remove red liner. Press adhesive to mounting base of razor holder. 4. Remove black liner. Press razor holder to surface for 10 seconds. 5. Important: for maximum holding strength slide razor holder up to remove from mounting base. 6. Press base firmly for 30 seconds. 7. Slide razor holder on to mounting base. 8. Wait 1 hour before use. To remove: 1. Slide razor holder up to remove from mounting base. 2. Never pull strip towards you. Strip could break or damage surface if pulled outward. 3. Hold base gently to prevent base from snapping fingers. Do not press base against wall. 4. Stretch strip straight down along wall at least 12 inches until base and strip release. Important: failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit

Country of Origin





3M Center, St. Paul, MN 55144-1000