Command Damage-Free Caddy Hanger

Command Damage-Free Caddy Hanger

1 ea pkg

Warnings

Caution: do not use with wallpaper. May not adhere well to vinyl surfaces. Do not use for antiques, heirlooms, or other valuable or irreplaceable items. Do not hang items over beds. Note: apply to surfaces above 15 degrees F. adhesive could lose adhesion above 125 degrees F.

Details

Command™ Brand Bath Caddy Hanger Damage-Free. Holds strongly in wet conditions. Tested & proven to hold better than suction cups. Water resistant adhesive strips. 1 caddy hanger. 2 large adhesive strips. 3M. Holds 7.5 lb. Not intended for picture hanging. Instead use Command™ picture hanging strips, sawtooth or wire-backed hangers. Caddy hanger can be reused with blue Command™ large water resistant strips. The following statements only apply to products distributed in the USA. Limited warranty: this 3M product will be free from defects in material and manufacture. If this product is defective, your exclusive remedy shall be, at 3M's option replacement of the product or refund of the purchase price. Limitation of liability: 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential. Caddy made in Mexico; strips and alcohol wipe made in U.S.A., with U.S. and globally sourced materials. 1-800-934-7355. For questions, ideas and special offers go to command.com. ©2013, 3M. All rights reserved.

To apply: 1. Select location: if possible, choose a location where strips are not over grout lines. Important: Allow space above hanger for removal. 2. Clean & dry surface clean surface with isopropyl rubbing alcohol, let dry. Do not use household cleaners to prep the surface. Separate strips. 3. Remove blue liner. Press adhesive to mounting base of hanger. Repeat with second strip. 4. Remove black liners. 5. Press hanger to surface for 10 seconds. 6. Important: for maximum holding strength slide hanger off. 7. Press each base firmly for 30 seconds. 8. Slide hanger on to mounting base. 9. If mounting in a shower or tub area: use shower at least once and then wait 24 hours to allow adhesive to build strength before attaching hanger. 1 hour: If mounting outside of shower or tub are: wait 1 hour to allow adhesive to build strength before attaching hanger. To remove: 1. Slide hanger up to remove from mounting base. Top rack dishwasher safe. 2. Never pull strip towards you. Strip could break or damage surface if pulled outward. 3. Straight down. Slowly. Hold base gently to prevent base from snapping fingers. Do not press base against wall. 4. Stretch strip straight down along wall at least 15 inches until base and strip release. Remove one strip at a time. Repeat steps with additional strips. Important: failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit command.com.

Country of Origin

Mexico,USA

Manufacturer

3M

Address

3M Center, St. Paul, MN 55144-1000

Phone

1-800-934-7355